Optional) Setting Communications Addresses For Air Conditioners - Huawei PowerCube 1000 Installation Manual

PowerCube 1000 (STC, Saudi Arabia, ICC800-A1-C2,
ESC800-A1)
Installation Guide
Table 12-23 Setting NetEco parameters
Main Second-Level
Menu Menu
Parameters Comm.
Settings Parameters
----End
BBU in-band Networking
Table 12-24 Setting the communications parameters for BBU in-band networking
Main Menu Second-Level
Menu
Parameters Comm.
Settings Parameters
12.2.13 (Optional) Setting Communications Addresses for Air
Conditioners
Prerequisites
The air conditioner address has been set by default. If you need to set it, perform
the following steps.
Scenario 1
If the air conditioner display panel is the one shown in the following figure, set air
conditioner communications addresses in the following way.
Issue 02 (2021-09-28)
Third-Level Fourth-Level
Menu Menu
Network NetEco
Parameters Primary IP
NetEco
Backup IP
NetEco Port
Number
Third-Level
Menu
Serial Port
M/S Protocol
Copyright © Huawei Technologies Co., Ltd.
12 Power-on and Commissioning
Default
Value
192.168.0.10
192.168.0.10
31220
Fourth-Level Fifth-Level
Menu Menu
Northbound Port Mode
Protocol Type
Baud Rate -
Comm. -
Address
Setting
Set this parameter
to the IP address of
the primary NetEco
server.
Set this parameter
to the IP address of
the backup NetEco
server.
Set this parameter
to the port number
of the NetEco.
Setting
Manual
M/S Protocol
9600
3
137