Huawei PowerCube 1000 Installation Manual page 143

PowerCube 1000 (STC, Saudi Arabia, ICC800-A1-C2,
ESC800-A1)
Installation Guide
Main Menu Second-Level
Menu
Step 2 Set IP addresses and port numbers for the primary and backup NetEco servers on
the LCD.
Table 12-21 Setting NetEco parameters
Main Menu Second-Level
Menu
Parameters Comm.
Settings Parameters
----End
Wireless Networking
Step 1 Check whether the default wireless communications parameters on the LCD are
consistent with the communication configurations of the carrier network that the
SIM card belongs to. If they are inconsistent, modify the parameters according to
the actual configurations of the carrier network.
Table 12-22 Checking wireless communications parameters
Main Menu Second-Level
Menu
Parameters Comm.
Settings Parameters
Issue 02 (2021-09-28)
Third-Level Fourth-Level
Menu Menu
Default
Gateway
Third-Level Fourth-Level
Menu Menu
Network NetEco
Parameters Primary IP
NetEco
Backup IP
NetEco Port
Number
Third-Level Fourth-Level
Menu Menu
Mobile Carrier
Data Operator
Copyright © Huawei Technologies Co., Ltd.
12 Power-on and Commissioning
Default Setting
Value
192.168.0.1 Set this parameter
according to the
address information
provided by the
network
administrator.
Default Setting
Value
192.168.0.10 Set this parameter
to the IP address of
the primary NetEco
server.
192.168.0.10 Set this parameter
to the IP address of
the backup NetEco
server.
31220 Set this parameter
to the port number
of the NetEco.
Default Setting
Value
Automatic Automatic, Others
135