Table of Contents
Advertisement
7700 MultiFrame Manual
7700SID(-AM) Source Identification Decoder
5.8.4. Warning Color Saturation
COLORS
WARNING
-128 to 127
-82
5.8.5. Error Color Saturation
COLORS
ERROR
-128 to 127
84
7700SID(-AM)-22
Adjust the saturation level of the "warning" (yellow) color
This control adjusts the saturation of the "warning" areas of the bar
graphs. This yellow is used to color the audio bar graphs region above
the program reference level and below the "error" region. The value
represents the Cb component of the yellow color. The default is the value
of the yellow bar of 75% color bars.
Note that this control only adjusts the saturation and not the luminance
(brightness) of the color. The brightness is controlled by the "White Level"
control.
Also, a grey is achieved by adjusting the value to zero and a blue color
by adjusting the value to a positive number.
Adjust the saturation level of the "error" (red) color
This control adjusts the saturation of the "error" areas of the bar graphs.
The red color is used to color the audio bar graphs region where levels
are approaching numerical saturation (0dB FS). The value represents the
Cr component of the red color. The default is the value of the red bar of
75% color bars.
Note that this only adjusts the saturation and not the luminance
(brightness) of the color. The brightness is controlled by the "Grey 2
level" control.
Also, a grey is achieved by adjusting the value to zero and a cyan color
by adjusting the value to a negative number.
Revision 0.3
Advertisement
Table of Contents
