Table of Contents
Advertisement
16.4. Advanced Acti-Feed Calibration
This section of Machine Preferences will alter the behavior of Acti-Feed. This will cause thread breaks to be
detected more or less frequently and make tighter or looser embroidered stitches.
Changing these settings will alter the way the thread is fed to the cloth and the accuracy of thread
break detection.
If using a different bobbin tension than that explained in
these sliders will most likely need adjusting to maintain appropriate Acti-Feed and thread break
detection.
Standard Embroidery
The Standard Embroidery slider will affect the loft of the stitches on standard embroidery. This includes any
embroidery without the additional color sequence effects of 3D Foam or Looping stitches applied to it.
Feed Adjust:
Sliding this slider to the right will create looser stitching.
·
This could also increase false bobbin breaks or create looped stitches.
o
Sliding this slider to the left will create tighter stitches.
·
This could also increase fabric ripples and design distortion from push/pull.
o
Thin or
Thick 3D Foam
Feed Adjust:
Sliding this slider to the right will create looser stitching.
·
This could also increase false bobbin breaks or create looped stitches.
o
Sliding this slider to the left will create tighter stitches.
·
This could also increase fabric ripples and design distortion from push/pull.
o
Caution!
Information
the Bobbin Threading &
91
Tensioning section,
Advertisement
Table of Contents
