Bernina E 16 PRO User Manual page 145

Marking this measurement on the cap with masking tape or tailor's chalk works well. Use the physical up or
down arrow to move the hoop into position. As you use these buttons, the machine's laser will illuminate the
placement.
Centering Horizontally
With the cap frame loaded on the machine, use the physical left or right arrow buttons to center the cap
horizontally. If the cap has six panels, you will have a seam running down the middle of the front. This acts as
a marker for center. If the cap has five panels, it will not have a seam, and you may need to use a tape
measure and tailor's chalk to find the center.
Using the laser to line up to the center may not work as well in this case. As the cap comes off of the needle
plate, the laser is displayed farther to the right. This is from the laser being set just behind the right upper
arm front cover of the machine.
For more accurate placement, line up the active needle (the needle with the presser foot behind it).
Trace the Design
Tracing the design using the hoop and trace keys simultaneously on the keypad of the machine will also give
you a good idea of where the design will be sewn.
145