Bernina E 16 PRO User Manual page 40

Return to Origin
If not at design origin (start of design before any machine movements have occurred), the Load Design
button will be swapped for the Return to Origin button. This button will return the machine to the very start
of the design.
This may or may not be the same as the first needle penetration. That is decided by the digitizer of
·
the design.
Color Sequence
Color Sequence goes into the color sequence screen. This allows you to set up the sequence for all the color
changes within a design. Effects and interrupt commands can be added to the color sequence to create stops
for thread cone changes or bobbin checks on larger designs.
This is only available when the machine is stopped.
·
Once running, this space indicates the current color and needle.
·
Hoop Selection
Use hoop selection to tell the machine what hoop is being used. This will indicate if the design will fit within
the selected hoop and prevent hoop strikes with the needle.
Machine Sew Speed
This reflects the maximum speed the machine will run. The machine may automatically slow
for longer stitch movements in X, Y, and also Z. Longer stitches, as well as higher thread feed values, may
affect speed.
Changing Machine Speed
The machine speed may be altered by clicking or tapping the plus or minus button on either side of the speed
setting.
40