Table of Contents
Advertisement
25. Sewing Caps
Sewing caps will require a little more setup than sewing a flat product. For sewing caps, you
will need to do the following.
1. Select the appropriate hoop in the application.
2.
Install the Wide-Angle Driver.
This may need adjusting the first time.
o
3.
Hoop a cap.
4. Load the hooped cap onto the driver.
5. Set up the design for caps
6. Load the design and set the proper settings for sewing caps.
7. Adjust the presser foot for the cap.
8. Center the design on the cap.
The next few sections of this document will assist in sewing a cap.
133
Advertisement
Table of Contents
