Bernina E 16 PRO User Manual page 58

After an Appliqué command has stopped the machine, starting the machine will move
§
the hoop back into place and continue sewing the design.
Pause - Placing this command between color blocks will cause the machine to stop and
o
wait to be restarted, but it will not move the hoop forward.
This command is often placed in designs larger than a single bobbin can sew as a
§
reminder to replace the bobbin.
Effects
·
Thinner 3D - Placing this effect on a color block will adapt the Acti-Feed of the affected
o
block for use with thinner 3D embroidery foam (typically 2mm foam).
This effect is often preceded by a pause or applique command to place the foam.
§
Thinner 3D - Placing this effect on a color block will adapt the Acti-Feed of the affected
o
block for use with thicker 3D embroidery foam (typically 3mm foam).
This effect is often preceded by a pause or applique command to place the foam.
§
Looping - Thinner 3D - Placing this effect on a color block will adapt the Acti-Feed of the
o
affected block for use with thicker thread and intentionally overfeeds, creating loops in the
stitches.
This command is often placed in designs that were created for use with this technique
§
and for use with a thicker, fuzzier thread.
§
Adding/Removing Commands & Effects to the Color Sequence
To add a command or effect to the color sequence,
1. Tap to select the color block in the color sequence.
2. Tap on the command or effect to be added.
Commands are added after the selected color block and appear with the sequence.
o
Effects are added to the selected color block and appear as an overlay to the color block.
o
To remove a command or effect to be removed from the color sequence,
1. Tap on the command or effect to be removed.
Commands are displayed and selectable as a block within the sequence.
o
58