Table of Contents
Advertisement
25.2. Loading a Hooped Cap
To load a hooped cap onto the installed wide-angle driver, use the following steps.
1. Rotate the hooped cap 90° to allow the bill to pass under the needle case.
2. Rotate the bill back up so that it is behind the needle case and the location tab on the driver aligns
with the notch in the frame.
3. This also aligns the rectangular holes along the edge of the frame with the spring-loaded locking
clamps on the driver.
4. With the frame aligned, press the frame toward the driver until the three (3) spring-loaded locking
clamps snap into place. It may be helpful to grasp the back of the driver and close your grip to push
the cap into place as pictured.
141
Advertisement
Table of Contents
