Design Filter - Bernina E 16 PRO User Manual

16.2. Design Filter

Stitch Filters
These filters add or remove needle penetrations along existing lines based on the settings below.
Maximum Stitch Length
·
If a stitch exceeds this amount, a needle penetration will be added to evenly divide the stitch
o
into lengths that fall below this threshold.
Short Stitch Length
·
This defines a "Short Stitch" for the next filter setting.
o
Delete Short Stitches
·
If a stitch falls below the defined "Short Stitch Length", needle penetrations will be filtered out
o
until a stitch remains that exceeds this defined length.
Ties and Trims
Tie and Trims settings are only applied upon design (re)load.
Optimize Ties
·
When enabled, this adds a small stitch on either side of a trim command. This may help hold
o
the thread if the ties in the design are insufficient.
Convert Jumps to Trim
·
When enabled, this filter counts consecutive jumps. If the number of consecutive jumps in a
o
design meets or exceeds the specified Count to Convert, those jumps will be converted to trim
commands.
Some embroidery design files will not or cannot contain explicit jump commands. These designs may
rely on this setting to create machine trim commands within a color block.
Information
Information
84