Installing The Wide-Angle Driver - Bernina E 16 PRO User Manual

24. Installing the Wide-Angle Driver

Cap frames and micro clamps utilize the Wide-Angle Driver. The Wide-Angle Driver consists
of two pieces.
The cap frame driver ring
·
The lower arm bracket
·
You must ALWAYS select the proper frame/hoop in the software when sewing with the Wide-Angle Driver.
Failure to do so may result in damage to your equipment!
Wide-Angle Driver Installation
1. Select the Wide-Angle Cap Frame for the hoop in the software.
a. Tap to select a hoop
b. Tap to select the Wide-Angle Driver Category
c. Locate and select the Wide-Angle Cap Frame
d. Confirm to return the main screen
2. Center the sewfield.
a. Tap to go to the Transform screen
b. Tap to center the sewfield of the Wide-Angle Cap Frame
c. Confirm to return to the main screen.
3. Moving the machine to either needle 8 or needle 9 is also beneficial.
a. Tap to access the move-to-needle option.
b. Tap to select either needle 8 or 9.
c. Confirm to move the needle case and return to the main screen.
4. If attached, remove the hoop arms from the machine. To do this, use a 6mm Allen wrench to loosen
the two thumb screws securing each arm. Unscrew them and remove the arms.
124