Table of Contents
Advertisement
Failure to remove the hoop arms will result in the wide-angle driver colliding with the arms during
sewing.
5. Remove the hook guard.
a. Loosen the thumb screw securing the hook guard and slide it away from the machine.
b. Set aside.
6. Loosen the knobs of the lower shaft support until the top of the screws are flush with the t-nut.
7. Slide the shaft support mount into the lower arm extrusion and toward the back of the machine until
it contacts the hard stop. It should slide smoothly into the t-channel. The t-nut must go all the way
back to the hard stop or the shaft will be set too far forward on the machine.
8. Tighten the two knobs.
9. Reattach the hook guard by sliding it back into place and tightening the thumb screw.
Warning!!
125
Advertisement
Table of Contents
