Powering Up The Machine - Bernina E 16 PRO User Manual

4.3. Powering Up the Machine

Connecting the Power Cable
1. Locate the power cable you will be using with your machine.
2. Locate the power cable plug in the rear of the machine.
3. Make sure the machine power switch is in the OFF position. Plug the power cable into the inlet.
4. Connect the power cable to a power source.
It is recommended that a line conditioner or an uninterruptible power supply with a line conditioner
be used with your machine. If using this, connect the power cord to the conditioner, and the
conditioner to the power source.
Initial Power Up
1. Make sure the E-Stop is disengaged by turning it in the direction of the arrows.
2. Power up the machine with the power switch located on the rear of the machine (just above the
power inlet).
Information
20