Table of Contents
Advertisement
9. Press the thread into the felt restraint and feed it down through the lower thread guide.
10. Thread the needle from front to back. Cutting the end of the thread may allow it to more easily pass
through the eye.
11. Be sure to align the thread with the small v-notch in the thread feed cover.
12. Press the black tab to lower the pinch roller.
13. If desired, the thread can then be held by the retaining spring in front of the lower thread guide
or held in place using the grabber. With your hands out of the way, tap the
In button to close the grabber and move the thread into the holder behind the needles.
14. Trim the end to about an inch in length.
28
Grabber In / Grabber
Advertisement
Table of Contents
