Table of Contents
Advertisement
19. Loading a Hoop onto the Machine
1. Install a hoop by sliding the side brackets of the hoop underneath the spring clips on
the support arms. Make sure that the slotted bracket is to the right as you are facing
the machine.
2. Slide the hoop towards the rear of the machine until it snaps into place and the brackets are fully
seated beneath the spring clips.
3. Pull back gently on the hoop arms to ensure the spring clips are engaged.
4. Run your fingers around the edges of the hoop to ensure that sleeves, collars, zippers, or other
garment parts are not inadvertently under the hoop. Balloon the garment out around the cylindrical
lower arm. This will prevent other garment parts from becoming sewn into the underneath side of the
embroidery.
111
Advertisement
Table of Contents
