Bernina E 16 PRO User Manual page 123

Removing the Hoop Support Arms
1. Use a 6mm hex wrench to loosen each of the two thumb screws attaching each arm to the x-carriage.
2. Using your fingers, fully loosen the thumb screws.
3. Remove the support arms from the x-carriage.
Adjusting the Spring Clips
When you have a hoop installed, you should make sure both spring clips are attached securely to the arms. If
either side of the hoop can move front to back underneath the clip, the clip needs to be adjusted. It may be
necessary to move the hoop forward for easier access to the nuts holding the clips. To adjust the clip:
1. Use a 5mm Hex nut driver to loosen the two nuts holding the clip in place.
2. Push the block underneath the clip as far forward as it will go.
3. Hold the block in place while tightening the nuts.
123