Dtmf Control Functions - Bosch Solution 16plus Installation Manual

DTMF CO NT RO L FUNCTI ONS
The control panel includes comprehensive DTMF control of
individual areas and outputs with full user PIN and TIMER
GROUP access verification.
Unlike other systems, no additional hardware or modules are
required for DTMF control. To configure the desired functions
see MENU 5-3-5 DTMF Options.
How to Use DTMF Control
1. Once the panel answers the incoming call, if either option 1,
2, 3 or 4 in MENU 5-3-5 is enabled, then the panel will play a
short welcome jingle. You now have approximately 5 seconds
to enter a valid PIN and log onto the panel.
2. Enter PIN followed by the # key. If the PIN is valid the system
will respond with two short beeps. If the PIN is invalid then a
single long beep will be heard.
If a valid PIN is not entered in time, the panel will attempt
to establish a modem connection as if connecting to the
SolutionLink software.
If this happens you will need to hang up for approximately 60
seconds before trying again.
3. Once validated, the following commands can be performed.
See the table below. If no keys are pressed for 20 seconds then
the panel will play the exit jingle before terminating the session
and hanging up. Pressing ## at any time while connected will
cause the panel to terminate the session.
DTM F CO NT ROL FUNC T ION S
Operation
Quick Arm
All Areas
Log In
USER PIN
OK
Log In
USER PIN
Failed
Turn Area
1
+ (Area Nº1-8) +
ON
Turn Area
1
+ (Area Nº1-8) +
OFF
Turn Output
2
+ (Output Nº1-16) +
ON
Turn Output
2
+ (Output Nº1-16) +
OFF
End
Session
Table 17: DTMF Remote Control Functions
Bosch Security Systems 05/10 BLCC100I
Command Response
0 #
2 x Beeps
+
Welcome
#
+
#
Long Beep
+
2 x Beeps
1 #
+
(Low - High)
2 x Beeps
2 #
+
(High - Low)
2 x Beeps
1 #
+
(Low - High)
2 x Beeps
2 #
+
(High - Low)
#
Exit Jingle
# +
Solution 16
DTMF EXAMPLES
Each example below shows the log on step for clarity. In practise
is only necessary to log on once per DTMF control session.
To turn Area 1 ON enter the following
2 + 5 + 8 + 0 + #
1 + 1 + 1 + #
To turn Output 10 ON enter the following
2 + 5 + 8 + 0 + #
2 + 10 + 1 + #
To turn Output 12 OFF enter the following
2 + 5 + 8 + 0 + #
2 + 12 + 2 + #
i
If the DTMF Quick Arm option is enabled then it is possible to
remotely arm all areas without logging onto the panel.
Simply enter 0 + # following the welcome jingle.
Note
Make sure that the phone being used to remotely control the
panel is set to transmit DTMF tones when keys are pressed
during the call. This option is disabled by default on some
phones.
Jingle
plus Installation Manual Programming Overview
 
= Log ON
= Arm Area 1
= Log ON
= Turn Output 10 ON
= Log ON
= Turn Output 12 OFF
4-5