Delete Keyfob; Test Keyfob; User Properties; User Name - Bosch Solution 16plus Installation Manual

Ur001 John Smith
Ur002 Debbie Smith
Ur003 User 3 Name
Press  OK or MENU
2) Enter the RF Keyfob ID Number.
Enter Keyfob RFid for
Ur002 Debbie Smith
009553507
Press OK or MENU
Press [OK] to save and exit or press [MENU] to exit without
3)
saving.
Access > RF Keyfob >

Delete Keyfob

This command allows the Installer or a Master User to delete an
RF Keyfob ID that has been assigned to a user.
1) Enter [MENU] + [1] + [3] + [1] and use the up and down arrows
to highlight the user in the list then press [OK]. The system will
only list users that have an RF Keyfob assigned.
Ur001 John Smith
Ur002 Debbie Smith
Ur003 Mary Smith
Press  OK or MENU
2) Press [OK] to delete the RF Keyfob ID number and exit or press
[MENU] to exit without saving.
OK to delete keyfob for
Ur002 Debbie Smith
009553507
Press OK or MENU
Access > RF Keyfob >

Test Keyfob

This menu allows the installer to test the RF Keyfob operation.
Key the transmitter a number of times and the display will show
the number of transmissions received and a signal level of
GOOD, BAD or AVERAGE.
Enter [MENU] + [1] + [3] + [2] and use the up and down arrows
1)
to highlight the user in the list then press [OK]. The system will
only list users that have an RF Keyfob assigned.
Ur001 John Smith
Ur002 Debbie Smith
Ur003 User 3 Name
Press  OK or MENU
2) Press any key on the transmitter you wish to test.
Bosch Security Systems 05/10 BLCC100I
-
MENU 1-3-1
 
.
MENU 1-3-2

Solution 16
plus Installation Manual

Ur002 Debbie Smith
Waiting for Trigger!
Press OK or MENU
3) If the system receives the signal the following screen will
appear.
Ur002 Debbie Smith
Transmissions = 001
Signal = Average
Press OK or MENU
4) Repeat step 2 as required and then Press [OK] to exit.
USER PROPER TI ES
This section outlines user properties including User Name, Area
Assignment, User Options, Erase User and Access Group.
Access > User Properties >

User Name

U s e r 1
This menu allows the security Installer or a Master user to
program the user's name (max of 16 characters). This name is
used for System Greetings, Reporting and Log entries to identify
the user by name.
Enter [MENU] + [1] + [4] + [0] and use the up and down arrows
1)
to highlight the user in the list then press [OK].
Ur001 John Smith
Ur002 Debbie Smith
Ur003 User 3 Name
Press  OK or MENU
2) Use the arrow and number keys to move and change text.
When the User Name is complete, press [OK]. At any time you
can press the [OFF] key to clear the text from the current cursor
position to the end of the line.
User Name Ur001
User 1 Name
Press  OK or MENU
i
See Alpha Text Programming in Section 4 — Programming
Overview for further detail on entering alpha text.
Note
Access Programming

-
MENU 1-4-0
 
N a m e
5-5