Bosch Solution 16plus Installation Manual page 99

Default Memory
TBA
Service Mode
This trouble message will display while the system is in Installer
Service mode. See MENU 7-0-8 — Service Mode
Phone In Use
This trouble message will display while the panel is using the phone
line. The message will clear when the line is released. This message
can be prevented from displaying in MENU 5-2-2 — Phone Line
Options.
System > Commands >
History Log
This command allows you to review the last 256 history events
in chronological order. Each log entry provides a wealth of
information about the event including log even number, time
and date stamp, user and zone names and the report route used.
When you enter the history log the most recent event will
always be shown first. Once the log memory is full it will wrap
and begin overwriting the oldest event in memory.
Each event will show:
Line 1 Displays:
Log Event Number, Event Date & Time and Report Destination
1 and /or 2 report status (S= Sent, P = Pending, F = Fail, A =
Abort and L = Log Only).
Line 2 Displays:
Displays the source of the event (eg. zone name and zone
number or user name and user number)
Line 3 Displays:
Displays the event description (eg. Walk Test Exited A1).
Press [MENU] + [7] + [0] + [2]. The keypad will display the most
1)
recent event from the history log.
E001 Mon,01Oct 03:41 SL
Ur001 User 1 Name
Walk Test Exited A1
Press  OK or MENU
2) Use the up and down arrows keys to scroll between history
events .
When finished press [OK] or [MENU] to exit.
3)
System > Commands >
Domestic Default
This command will configure the control panel for Domestic
format reporting (eg. mobile telephones etc). All alarm restore
reports and open/close reporting options will be automatically
disabled. Therefore, only emergency, burglary and fire reports
will be sent.
1) Press [MENU] + [7] + [0] + [3]. The keypad will display:
Bosch Security Systems 05/10 BLCC100I
- -
MENU 7-0-2
  
MENU 7-0-3

Solution 16
plus Installation Manual

To Reconfigure all panel
dialler programming to
DOMESTIC, Press OK or To
Cancel,Press MENU.
2) Press [OK] to start the default process or press [MENU] to
cancel and exit.
3) The keypad will display the following message during the
default process and will exit back to the menu when finished.
Defaulting System
..Please Wait..
System > Commands >
Factory Default
This command will erase ALL programmable data and return
the control panel to factory default settings. Defaulting the
panel will NOT erase any history events that are currently stored
in the panel.
1) Press [MENU] + [7] + [0] + [4]. The keypad will display:
This command will ERASE
All panel programming. To
Continue Press OK, or
MENU to cancel
Press [OK] to start the default process or press [MENU] to cancel
and exit.
2) The keypad will display the following message during the
default process and will exit back to the menu when finished.
Defaulting System
..Please Wait..
i
During a factory default both the Status and Dialer LED indicators
on the panel will flash very quickly to indicate defaulting is still in
progress.
Note
System > Commands >
Template Default
This command allows the installer to download pre-configured
templates set up by the Installer on the MyAlarm web interface.
The installer can configure up to 4 separate templates.
This feature is currently reserved.
System Programming

MENU 7-0-4

MENU 7-0-5

11-3