Keysight E4428C ESG RF Programming Manual page 41

Configuring the VXI–11 for LAN (ESG/PSG)
Utility > GPIB/RS–232
LAN
NOTE
To communicate with the signal generator over the LAN, you must enable the VXI–11 SCPI service. Select VXI–11 until On is highlighted.
(Default condition is On.)
Use a 10Base–T LAN cable to connect the signal generator to the LAN.Where auto–negotiation is present, the ESG or PSG can connect to
100Base–T LAN, but will communicate at 10Base–T speeds. For more information refer to http://www.ieee.org.
Manual Configuration
The Hostname softkey is only available when LAN Config Manual DHCP is set to Manual.
To remotely access the signal generator from a different LAN subnet, you must also enter the subnet
mask and default gateway. See your system administrator for more information.
For more information on the manual configuration, refer to "Manually Configuring the Keysight MXG
LAN" on page 34 or to "Manually Configuring the ESG/PSG LAN" on page 34.
Keysight Signal Generators Programming Guide
For details on each key, use the Key and Data Field
Reference. For additional SCPI command
information, refer to the SCPI Command Reference.
Using IO Interfaces
Using LAN
33