Keysight E4428C ESG RF Programming Manual page 20

Getting Started with Remote Operation
Using the Web Browser
The instrument can be accessed through a
standard web browser, when it is
connected to the LAN. To access through
the web browser, enter the instrument IP
address or the hostname as the URL in
your browser.
The signal generator web page, shown at
right and page 16, provides general
information on the signal generator, FTP
access to files stored on the signal
generator, and a means to control the
instrument using either a remote
front- panel interface or SCPI commands.
The web page also has links to Keysight's
products, support, manuals, and website.
For additional information on memory
catalog access (file storing), and FTP, refer
to the User's Guide and "Waveform
Memory" on page 228 and for FTP, see
"Using FTP" on page 48 and "FTP Procedures"
on page 240.
The Web Server service is compatible with
the Microsoft Internet Explorer (6.0 and
newer) web browser and operating systems
Windows 2000, Windows XP, and newer.
For more information on using the Web
Server, refer to "Enabling the Signal
Generator Web Server" on page 14.
12
The Keysight MXG supports LXI Class B*
functionality. For more information on the LXI
standards, refer to http://www.lxistandard.org/home.
*LXI Class B Compliance testing using IEEE
1588-2008 not available at release.
Note:
If you do not see this window, check to see if the window is hidden behind
your browser window or your web browser settings are set to block pop-ups.
To use this feature, you need to set your web browser to allow pop-ups for
your instrument's IP address.
Remote SCPI commands requires the Telnet feature on the computer. The
Telnet feature is available from a variety of sources. Some software updates
can block (break) this Telnet connection (e.g. Internet Explorer 7). When
using Internet Explorer as a browser, only versions <Internet Explorer 7
enable the Web-Enabled MXG SCPI feature.
If the "SCPI Telnet" softkey is not active, to display the SCPI Telnet box:
1) On the PC, click Start > Run
2) In the dialogue box type: Telnet [IP address of MXG] 5024 [This
is the port number for connecting to the MXG.]
Note: Telnet port 5023 is available for backwards compatibility (i.e. for
firmware versions <A.01.50).
Keysight Signal Generators Programming Guide
To operate the signal generator, click the
keys.