Keysight E4428C ESG RF Programming Manual page 193

Table 4-7 Standard Operation Condition Register Bits
Bit Description
0 Unused. These bits are always set to 0.
1 Settling. A 1 in this bit position indicates that the signal generator is settling.
2 Unused. This bit position is always set to 0.
3 Sweeping. A 1 in this bit position indicates that a sweep is in progress.
4 Unused. These bits are always set to 0.
5 Waiting for Trigger. A 1 in this bit position indicates that the source is in a "wait for trigger"
state.
6,7,8 Unused. These bits are always set to 0.
9
DCFM/DCφM Null in Progress. A 1 in this bit position indicates that the signal generator is
currently performing a DCFM/DCΦM zero calibration.
10 Unused. These bits are always set to 0.
11 Sweep Calculating. A 1 in this bit position indicates that the signal generator is currently doing
the necessary pre- sweep calculations.
12, 13, 14 Unused. These bits are always set to 0.
15 Always 0.
Query:
STATus:OPERation:CONDition?
Response: The decimal sum of the bits set to 1
Example: The decimal value 520 is returned. The decimal sum = 512 (bit 9) + 8 (bit 3).
Standard Operation Transition Filters (negative and positive)
The Standard Operation Transition Filters specify which types of bit state changes in the condition
register set corresponding bits in the event register. Changes can be positive (0 to 1) or negative (1
to 0).
Commands:
Queries:
Keysight Signal Generators Programming Guide
STATus:OPERation:NTRansition <value> (negative transition), or
STATus:OPERation:PTRansition <value> (positive transition), where
<value> is the sum of the decimal values of the bits you want to enable.
STATus:OPERation:NTRansition?
STATus:OPERation:PTRansition?
Programming the Status Register System
Status Groups
185