Keysight E4428C ESG RF Programming Manual page 123

GPIB Address Assignments
Figure 3-1 describes how GPIB addresses should be assigned for sending pass- thru commands. These
are the same addresses used in Example 3-1.
Table 3-1
Instrument
PSG/E8663B
8757D
8757D (Sweeper)
Pass Thru
Example Pass-Thru Program
Example 3-1 on page 115 is a sample Keysight BASIC program that switches the 8757D to pass- thru
mode, allowing you to send operating commands to the PSG. After the program runs, control is given
back to the network analyzer. The following describes the command lines used in the program.
Line 30 PT is set to equal the source address. C1 is added, but not needed, to specify the
channel.
Lines 40, 90 The END statement is required to complete the language transition.
Lines 50, 100 A WAIT statement is recommended after a language change to allow all instrument
changes to be completed before the next command.
Lines 70, 80 This is added to ensure that the instrument has completed all operations before
switching languages. Lines 70 and 80 can only be used when the signal generator
is in single sweep mode.
Line 110 This takes the network analyzer out of pass- thru command mode, and puts it back
in control. Any analyzer command can now be entered.
NOTE Verify the signal generator is in single sweep mode. Refer to the SCPI Command Reference
or the User's Guide, as required.
Example 3-1 Pass-Thru Program
10 ABORT 7
20 CLEAR 716
30 OUTPUT 716;"PT19;C1"
Keysight Signal Generators Programming Guide
GPIB Key Presses/Description
Address
19 Press Utility > GPIB/RS-232 LAN > GPIB Address > 19 > Enter.
Press LOCAL > 8757 > 16 > Enter.
16
19 This address must match the PSG.
Press LOCAL > SWEEPER > 19 > Enter.
17 The pass thru address is automatically selected by the 8757D by inverting
the last bit of the 8757D address. Refer to the 8757D documentation for
more information. Verify that no other instrument is using this address
on the GPIB bus.
Programming Examples
GPIB Programming Interface Examples
115