BMW iX 2024 Owner's Handbook Manual page 74

CONTROLS
▷ The vehicle cannot be used during installa-
tion.
▷ You may leave the vehicle during installa-
tion.
▷ The vehicle charging process is interrupted
by the installation.
▷ Following the successful installation, charg-
ing the vehicle may not continue automati-
cally.
Prerequisites for the installation
▷ The vehicle battery is sufficiently charged.
▷ The outside temperature is above -10 ℃,
14 ℉.
▷ The vehicle is parked on level ground.
▷ The hazard warning lights are switched off.
▷ The selector lever position P is engaged.
▷ Drive-ready state is switched off.
If applicable, follow the notes for further pre-
requisites on the control display.
If the prerequisites are not met, for example
a sufficient vehicle battery charge state, the
upgrade will not be offered for installation.
Look out for an offer to install, for example
after charging the battery for a long period.
Preparing the vehicle
▷ Park the vehicle safely away from the public
road.
▷ Cellular network reception must be ensured
so that a fault message can be sent to the
vehicle manufacturer, for example if the in-
stallation is terminated.
▷ Close the windows.
▷ Closing the luggage compartment
▷ Remove devices that consume energy, for
example mobile phone.
▷ Disconnect the trailer or load carrier.
▷ The vehicle key must be located in the vehi-
cle for the consent for installation.
74
BMW Remote Software Upgrade
Online Edition for Part no. 01405A7AFB2 - II/23
▷ Switch off the exterior lights.
▷ Remove the devices connected to the
socket for on-board diagnosis.
Install immediately
The upgrade can be installed immediately
when all prerequisites have been met.
1. Apps menu
2. "All apps"
3. "System settings"
4. "Remote Software Upgrade"
5. "Start upgrade now"
6. Follow the instructions on the control dis-
play.
Installing with timer
At the end of the journey, a timer can be used
to install the upgrade automatically at a config-
ured time, for example, during the night. It may
make sense to install later to meet functional
requirements, such as a sufficiently charged
vehicle battery.
1. Apps menu
2. "All apps"
3. "System settings"
4. "Remote Software Upgrade"
5. Select the desired settings.
The installation starts automatically when:
▷ All prerequisites for the installation have
been established correctly.
▷ All prerequisites continue to be met at the
time of installation.
The timer is turned off when the drive-ready
state is turned on.
Functional limitations
During the upgrade, many of the functions are
temporarily unavailable, for example:
OwnersManuals2.com