BMW iX 2024 Owner's Handbook Manual page 350

MOBILITY
Charging in the time window
General
A time window can be set for charging, for ex-
ample to charge with a cheap electricity rate.
The vehicle can also start the charging process
before the selected time window begins or end
it after the selected time window finishes. The
starting point of the charging process is adjus-
ted so the vehicle can be charged as much as
possible and, if applicable, be air conditioned
right up to the departure time.
Operating requirements
A departure time is defined.
Setting the time window for charging
1. Apps menu
2. "Vehicle apps"
3. "Charging"
4. "Charging mode"
5. "Time slot"
6. Select the desired setting.
Target charge
Principle
A percentage target value can be set when
charging the high-voltage battery.
If a lower target value is set, the charging time
can be shortened.
General
Charging with a set charging target is recom-
mended in particular when charging the vehi-
cle at a DC charging station.
To make optimum use of the function, a target
value of 80 % is recommended.
Target values below 20 % cannot be set.
350
Charging the vehicle
Online Edition for Part no. 01405A7AFB2 - II/23
Setting the target charge
1. Apps menu
2. "Vehicle apps"
3. "Charging"
4. "Charging target"
5. Select the desired setting.
Permissible DC charging volume
If the vehicle is charged at a DC charging
station, the noise emissions that occur during
charging process can be restricted in order to
comply with local noise regulations, for exam-
ple. Restricting the noise emissions may result
in longer charging times.
1. Apps menu
2. "Vehicle apps"
3. "Charging"
4. "Fan loudness"
5. Select the desired setting.
Stopping charging process
When the vehicle is charged using a Mode 2
charging cable or a Mode 3 charging cable, the
charging process will be interrupted when the
vehicle is unlocked. The charging process will
then be continued automatically after a short
period of time or when the vehicle is locked.
The charging process can be terminated at
any time by removing the charging cable, and
resumed at a later point by connecting the
charging cable. For example, so that other
people can use the electrical connection in the
meantime or in order to avoid excessive load
on the electrical connection.
For further information:
Removing, see page 346.
Resuming charging process
If charging is interrupted, for example, by un-
locking the vehicle or due to a temporary
OwnersManuals2.com