BMW iX 2024 Owner's Handbook Manual page 303

Programming the integrated
universal remote control
Operating requirements
The battery in the hand-held transmitter must
be fully charged during programming to en-
sure the integrated universal remote control
will have the optimum range.
Programming individual buttons
1. Park your vehicle within the range of the
radio remote-controlled system.
2. Switch on standby state.
3. Select desired button on the interior mirror:
▷ Program available button:
Press the key.
▷ Program already assigned button:
Press and hold the button for approx.
20 seconds.
The LED on the interior mirror flashes or-
ange slowly.
4. Hold the hand-held transmitter for the
remote-controlled system approx. 2.5 to
30 cm, 1 to 12 in away from the buttons on
the interior mirror.
The distance required depends on the
hand-held transmitter.
5. Press and hold the button on the hand-held
transmitter.
6. The LED can illuminate in various ways:
▷ The LED is illuminated green: program-
ming is complete.
Release button.
▷ The LED flashes green rapidly: the
hand-held transmitter was detected but
programming is not complete.
Press and hold the button on the interior
mirror for approx. 2 seconds. Perform
this procedure three times.
If the integrated universal remote con-
trol remains non-operational, continue
Online Edition for Part no. 01405A7AFB2 - II/23
Interior equipment
with the special features for alternating-
code radio systems.
▷ LED does not illuminate green after
60 seconds: programming not comple-
ted.
Repeat steps 3 to 5.
Special instruction for alternating-code
radio systems
For systems with an alternating-code radio
system, the integrated universal remote con-
trol and the system must also be synchron-
ised.
Refer to information on synchronisation in the
operating instructions of the remote-controlled
system.
1. Program the desired button on the interior
mirror.
2. Locate and press the synchronising button
on the remote-controlled system, for exam-
ple, on the garage door.
The next step must be carried out within
approximately 30 seconds.
To make synchronisation easier, enlist the
assistance of a second person.
3. Press and hold the programmed button on
the interior mirror for approx. 3 seconds.
Repeat this step as needed up to three
times to end synchronisation. When syn-
chronisation is completed, the programmed
function is performed.
Operation
After programming, the remote-controlled sys-
tem can be operated with the button on the
interior mirror.
Press and hold the desired button of the re-
mote-controlled system within range until the
function is triggered.
The LED on the interior mirror is continuously
illuminated green during the transmission of
the radio signal.
CONTROLS
303
OwnersManuals2.com