BMW iX 2024 Owner's Handbook Manual page 364

Table of Contents

Advertisement

MOBILITY
other qualified Service Partner or a special-
ist workshop.
6.
Correct the tyre pressure to 2.5 bar.
Increase tyre inflation pressure: with
standby or drive-ready state turned on,
turn on the compressor and let it run for
a maximum of 10 minutes.
Reduce tyre inflation pressure: press the
pressure reducing valve button on the
compressor.
Removing and stowing the tyre
repair kit
1.
Switch off compressor.
2.
Pull the connector out of the socket in the
vehicle interior.
3.
Disconnect the hose from the compressor
and the valve on the wheel.
4.
Screw the valve cap onto the valve.
5.
Stow the tyre repair kit in the luggage com-
partment.
Resuming a journey
Do not exceed the permitted maximum speed
of 80 km/h, approx. 50 mph.
Do not exceed a maximum distance travelled
of 200 km/125 miles.
Re-initialise the flat tyre monitor or reset the
Tyre Pressure Monitor.
Have the punctured tyre and the tyre sealant
bottle of the tyre repair kit replaced as soon as
possible.
For further information:
Flat Tyre Monitor, see page 371.
Tyre Pressure Monitor, see page 365.
System limits
Contact an authorised Service Partner or an-
other qualified Service Partner or a specialist
workshop if you are unable to put the tyre back
in operation.
364
Wheels and tyres
Online Edition for Part no. 01405A7AFB2 - II/23
With Tyre Pressure Monitor: using sealant can
damage the air pressure sensor. In this case,
have the electronics replaced at the next op-
portunity.
Snow chains
Safety information
WARNING
If snow chains are fitted to unsuitable tyres,
the snow chains can come into contact with
parts of the vehicle. There is a risk of accident
or material damage. Only fit snow chains on
tyres which have been approved by the man-
ufacturer as being suitable for snow chains.
WARNING
Insufficiently tensioned snow chains can
damage tyres and vehicle components.
There is a risk of accident or material dam-
age. Ensure that snow chains are always ad-
equately tensioned. Re-tension them if nec-
essary in accordance with the snow chain
manufacturer's instructions.
Fine-link snow chains
The vehicle manufacturer recommends using
fine-link snow chains. Certain fine-link snow
chains have been tested, found safe for use
in traffic and rated as suitable by the manufac-
turer of the vehicle.
Information regarding suitable snow chains is
available from an authorised Service Partner or
another qualified Service Partner or a specialist
workshop.
Use
Use only in pairs on the rear wheels, equipped
with the tyres of the following wheel/tyre sizes:
OwnersManuals2.com

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents