Table of Contents
Advertisement
Pre-Start Inspection
The Pre-Start Inspection should include each of the following:
1.
Cleanliness – Check all surfaces for leakage (oil, fuel, or
battery fluid) or foreign objects. Report any leakage to the
proper maintenance personnel.
2.
Structure - Inspect the machine structure for dents,
damage, weld or parent metal cracks or other discrepancies.
Parent Metal Crack
3.
Decals and Placards – Check all for cleanliness and
legibility. Make sure none of the decals and placards are
missing. Make sure all illegible decals and placards are
cleaned or replaced.
31215018
SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
Weld Crack
4.
Operation and Safety Manuals – Make sure a copy of the
Operation and Safety Manual, AEM Safety Manual (ANSI
markets only), and ANSI Manual of Responsibilities (ANSI
markets only) is enclosed in the weather resistant storage
container.
5.
Walk-Around Inspection – Perform as instructed.
6.
Battery – Charge as required.
7.
Fuel (Combustion Engine Powered Machines) – Add the
proper fuel as necessary.
8.
Engine Oil Supply - Ensure the engine oil level is at the Full
mark on the dipstick and the filler cap is secure.
9.
Hydraulic Oil – Check the hydraulic oil level. Ensure
hydraulic oil is added as required.
10.
Accessories/Attachments - Refer to the Accessories section
in this manual or accessory installed upon the machine for
specific
inspection,
instructions.
operation,
and
maintenance
2-5
Advertisement
Table of Contents
