Table of Contents
Advertisement
7.5
OPERATOR MAINTENANCE
NOTE:
The following numbers correspond to those in Figure 7.3,
Operation Maintenance and Lubrication Diagram - Deutz
D2011.
Table 7-14. Lubrication Specifications
KEY
MPG
Multipurpose Grease having a minimum dripping point of 350° F (177° C). Excel-
lent water resistance and adhesive qualities, and being of extreme pressure type.
(Timken OK 40 pounds minimum.)
EPGL
Extreme Pressure Gear Lube (oil) meeting API service classification GL-5 or MIL-
Spec MIL-L-2105
HO
Hydraulic Oil. API service classification GL-3, e.g. Mobilfluid 424.
EO
Engine (crankcase). Gas (5W30)- API SN, -Arctic ACEA AI/BI, A5/B5 - API SM, SL, SJ,
EC, CF, CD - ILSAC GF-4. Diesel (15W40, 5W30 Arctic) - API CJ-4.
OGL
Open Gear Lubricant - Mobiltac 375 or equivalent.
LUBRICATION INTERVALS ARE BASED ON MACHINE OPERATION UNDER NORMAL CONDI-
TIONS. FOR MACHINES USED IN MULTI-SHIFT OPERATIONS AND/OR EXPOSED TO HOSTILE
ENVIRONMENTS OR CONDITIONS, LUBRICATION FREQUENCIES MUST BE INCREASED
ACCORDINGLY.
31215018
SECTION 7 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
SPECIFICATIONS
NOTE:
It is recommended as a good practice to replace all filters at the
same time.
1.
Final Drive Hub
FILL
CHECK
Lube Point(s) - Level/Fill Plug
Capacity - 33.8 oz (1 L)(1/2 Full)
Lube - EPGL
Interval - Check level every 3 months or 150 hours of opera-
tion; change every 2 years or 1200 hours of operation
7-15
Advertisement
Table of Contents
