Run Indicator-Ld18; Atm On Indicator-Ld19; Fast Ethernet Port 1 Enabled-Ld20; Fast Ethernet Port 2 Enabled-Ld22 - Freescale Semiconductor MPC8272ADS User Manual

Table of Contents

Advertisement

Controls and Indicators
4.1.19 RUN Indicator—LD18
When the green RUN led - LD18 is lit, it indicates that the MPC8272 is performing cycles
on the PPC bus. When dark, the MPC8272 is either running internally or stuck.
4.1.20 ATM ON Indicator—LD19
When the yellow ATM ON led is lit, it indicates that the ATM-UNI transceiver PM5384 is
enabled for communication. When it is dark, the ATM-UNI transceiver is disconnected
from the MPC8272, enabling the use of its associated FCC1 pins off-board by using the
expansion connectors or for Fast Ethernet.
ATM ON led is controlled by BCSR1.
4.1.21 Fast Ethernet Port 1 Enabled—LD20
When the yellow ETH1 ON led is lit, the fast Ethernet port 1 transceiver DM9161 is
connected to FCC1. When it is dark, the DM9161 is in power-down mode and disconnected
from FCC1, enabling the use of its associated FCC1 pins off-board by using the expansion
connectors. BCSR1 controls the state of LD20.
4.1.22 Fast Ethernet Port 2 Enabled—LD22
When the yellow ETH2 ON led is lit, the fast Ethernet port 2 transceiver DM9161 is
connected to FCC2. When it is dark, the DM9161 is in power-down mode and disconnected
from FCC2, enabling the use of its associated FCC2 pins off-board by using the expansion
connectors. BCSR1 controls the state of LD22.
4.1.23 RS232 Port 1 ON—LD23
When the yellow RS232 Port 1 ON led is lit, the RS232 transceiver is connected to P13A
(upper DB9 connector), is active, and communication using that medium is allowed. When
it is darkened, the transceiver is in shutdown mode and its associated SCC1 pins may be
used off-board by using the expansion connectors.
4.1.24 Fast Ethernet Port 1 Full Duplex Indicator—LD1
When the Dm9161 on FCC1 is enabled and is in full duplex operation mode, the red led -
LD1 lights.
4.1.25 RS232 Port 2 ON—LD24
When the yellow RS232 Port 2 ON led is lit, the RS232 transceiver is connected to P13B
(lower DB9 connector), is active, and communication using that medium is allowed. When
Chapter 4. Operating Instructions

Advertisement

Table of Contents
loading

Table of Contents