Table of Contents
Advertisement
3.2
Connect Development Platform to PC; Run Preloaded
Image
Figure 3-5 illustrates the components and locations for the steps that follow.
To connect the 3-Stack platform to your host PC, use these steps:
1. Connect one end of an RS-232 serial cable (included in the kit) to a serial port connector
(CON4) on the Debug board and connect the other end to a COM port on the host PC.
⎯ Configure SW4-1 to ON.
⎯ Make sure that SW4-8 is ON, to supply power to all three boards.
⎯ Configure SW4-2 to OFF.
2. Confirm that the Bootstrap switches (SW5-SW10 on the Debug Board and SW1-SW2 on
the Personality board) are set for NAND boot. See Table 3.1 and Table 3.2.
Boot
SW5
Mode
Device
UART/USB
X
bootloader
8-bit NAND
X
Flash(2KB
page) Ext
3-4
Figure 3-5 Connecting the Platform to the PC
Table 3.1 Boot Mode Setting
SW6
SW7
0
0
1
0
i.MX35 PDK 1.5 Linux Quick Start Guide, Rev 1.5
SW8
SW9
0
1
0
1
Freescale Semiconductor
SW10
1
0
Advertisement
Table of Contents
