Table of Contents
Advertisement
88
GETTING TO KNOW YOUR VEHICLE
5. Reinstall the protective caps over the wiper
arm hex bolts and push gently until they
snap into place.
Step Five
1 — Hex Bolt Cover Installed
2 — Hex Bolt Cover Removed
NOTE:
Make sure the windshield is raised prior to
installing the tops.
HOOD
O
T
H
PENING
HE
OOD
Release both the hood latches.
Hood Latch Locations
Raise the hood and locate the safety latch,
located in the middle of the hood opening. Push
the safety latch to the left side of the vehicle to
open the hood. You may have to push down
slightly on the hood before pushing the safety
latch. Remove support rod from the hood, and
insert into the radiator crossmember.
C
T
H
LOSING
HE
OOD
To close the hood, remove the support rod from
the radiator crossmember, and install into the
clip on the hood. Lower the hood slowly. Secure
both of the hood latches.
WARNING!
Be sure the hood is fully latched before
driving your vehicle. If the hood is not fully
latched, it could open when the vehicle is in
motion and block your vision. Failure to follow
this warning could result in serious injury or
death.
Advertisement
Table of Contents
