Instrument Cluster Descriptions - Jeep GLADIATOR 2020 Owner's Manual

Hide thumbs Also See for GLADIATOR 2020:
Table of Contents

Advertisement

I
C
D
NSTRUMENT
LUSTER
ESCRIPTIONS
1. Tachometer
Indicates the engine speed in revolutions
per minute (RPM x 1000).
CAUTION!
Do not operate the engine with the
tachometer pointer in the red area. Engine
damage will occur.
2. Temperature Gauge
The temperature gauge shows engine
coolant temperature. Any reading within
the normal range indicates that the
engine cooling system is operating satis-
factorily.
The gauge pointer will likely indicate a
higher temperature when driving in hot
weather, up mountain grades, or when
towing a trailer. It should not be allowed
to exceed the upper limits of the normal
operating range.
WARNING!
A hot engine cooling system is dangerous.
You or others could be badly burned by steam
or boiling coolant. You may want to call an
authorized dealer for service if your vehicle
overheats.
CAUTION!
Driving with a hot engine cooling system
could damage your vehicle. If the
temperature gauge reads "H" pull over and
stop the vehicle. Idle the vehicle with the air
conditioner turned off until the pointer drops
back into the normal range. If the pointer
remains on the "H", turn the engine off
immediately and call an authorized dealer
for service.
GETTING TO KNOW YOUR INSTRUMENT PANEL
3. Instrument Cluster Display
The instrument cluster display features a
driver interactive display. Refer to "Instru-
ment Cluster Display" in this chapter for
further information.
4. Fuel Gauge
The pointer shows the level of fuel in the
fuel tank when the ignition switch is in
the ON/RUN position.
The fuel pump symbol points to the
side of the vehicle where the fuel filler
door is located.
Refer to "Refueling The Vehicle" in "Starting
And Operating" for further information.
5. Speedometer
Indicates vehicle speed.
111
3

Advertisement

Table of Contents
loading

Table of Contents