Table of Contents
Advertisement
LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps
they are replaced as an assembly.
Rear Tail, Stop, Turn Signal, And Backup
Lamp
1. Remove the two screws that pass through
the bed sheet metal.
Tail Lamp Screws
2. Pull the outboard side of the lamp rearward,
far enough to unsnap the two receptacles
on the outboard side of the lamp housing,
from the two plastic snap post retainers in
the outer box side panel.
3. Remove the screws from assembly bracket
to access the three bulb sockets.
Assembly Bracket
4. Rotate the appropriate socket a quarter
turn counterclockwise, then remove it from
the housing.
5. Pull the bulb straight from the socket to
replace.
Center High Mounted Stop Lamp (CHMSL)
The stop lamp is mounted on the tailgate. If
service is needed, obtain the LED assembly
from an authorized dealer.
License Plate Lamps
See an authorized dealer to replace these LED
assemblies.
IN CASE OF EMERGENCY
FUSES
WARNING!
When replacing a blown fuse, always use
an appropriate replacement fuse with the
same amp rating as the original fuse. Never
replace a fuse with another fuse of higher
amp rating. Never replace a blown fuse with
metal wires or any other material. Failure to
use proper fuses may result in serious
personal injury, fire and/or property
damage.
Before replacing a fuse, make sure that the
ignition is off and that all the other services
are switched off and/or disengaged.
If the replaced fuse blows again, contact an
authorized dealer.
If a general protection fuse for safety
systems (air bag system, braking system),
power unit systems (engine system,
gearbox system) or steering system blows,
contact an authorized dealer.
285
6
Advertisement
Table of Contents
