Table of Contents
Advertisement
32
GETTING TO KNOW YOUR VEHICLE
To remove the rear doors, proceed
as follows:
1. Roll down the glass window to
prevent any damage.
2. Remove the hinge pin nuts from the upper
and lower outside hinges (using a #T50 Torx
head driver).
NOTE:
The hinge pin nuts can be stowed in the
Fastener Bin under the rear seat.
Hinge Pin Nut
3. Slide the front seat(s) fully forward.
4. Pry open and remove the plastic wiring
access door from the bottom of the B-pillar.
Wiring Access Door
5. Unplug the wiring connector.
NOTE:
Squeeze the tab on the base of the wiring
harness. This will unlock the connector tab,
allowing the wiring connector to be unplugged.
Unhook the wire harness strap from the hook on
the bodyside door opening. Store the wire
connector into the lower basket of the door.
Wiring Connector
Advertisement
Table of Contents
