Table of Contents
Advertisement
Back Component Removal and Installation
BACK COMPONENT REMOVAL AND INSTALLATION
TEMPERATURE SENSOR REMOVAL
To remove the temperature sensor, first remove the top plate.
Remove the Top Plate
1
Use a T-20 Torx bit to remove the screws from the top and
back of the unit.
2
Remove the top plate from the unit.
Remove the Temperature Sensor
1
Disconnect the temperature sensor electrical connector
from the control board.
2
Use a T-20 Torx bit to remove the screw from the
temperature sensor.
3
Remove the temperature sensor from the unit.
TEMPERATURE SENSOR INSTALLATION
Install the Temperature Sensor
1
Insert the temperature sensor into the back of the unit.
827703 REV B.1
CSO (SWS #13543126)
2
Use a T-20 Torx bit to install the screw into the temperature
sensor.
3
Connect the temperature sensor electrical connector to the
control board.
Install the Top Plate
1
Place the top plate on the unit.
2
Use a T-20 Torx bit to install the screws into the top plate.
CSO RESISTOR REMOVAL
To remove the CSO resistor, first remove the top plate.
Remove the Top Plate
1
Use a T-20 Torx bit to remove the screws from the top and
back of the unit.
2
Remove the top plate from the unit.
Remove the CSO Resistor
1
Disconnect the electrical connector from the CSO resistor.
2
Use a T-20 Torx bit to remove the screw from the CSO
resistor.
72
service.subzero.com
Advertisement
Table of Contents
