Wolf CSO24TE/S General Information Manual page 77

Back Component Removal and Installation
Install the Rack (continued)
Install the Rack
1 Insert the rack between the rails of the rack guide.
2 Push the rack into the oven.
Install the Top Plate
1 Place the top plate on the unit.
2 Use a T-20 Torx bit to install the screws into the top plate.
DRAIN PUMP ASSEMBLY REMOVAL
To remove the drain pump assembly, first remove the top plate.
Remove the Top Plate
1 Use a T-20 Torx bit to remove the screws from the top and
back of the unit.
2 Remove the top plate from the unit.
Remove the Drain Pump Assembly
1 Disconnect the discharge hose to the water tank from the
drain pump assembly.
2 Disconnect the suction hose from the evaporator from the
drain pump assembly.
3 Use a flat-blade screwdriver to open the tabs on the drain
pump retainer.
4 Remove the drain pump assembly from the drain pump
retainer.
5 Disconnect the electrical connector from the drain pump
assembly.
827703 REV B.1
CSO (SWS #13543126)
6 Remove the drain pump assembly from the unit.
DRAIN PUMP ASSEMBLY INSTALLATION
Install the Drain Pump Assembly
1 Connect the electrical connector to the drain pump
assembly.
2 Insert the drain pump assembly into the drain pump
retainer.
3 Connect the hose from the water tank to the drain pump
assembly discharge.
4 Connect the hose from the evaporator to the drain pump
suction.
Install the Top Plate
1 Place the top plate on the unit.
2 Use a T-20 Torx bit to install the screws into the top plate.
DRAIN PUMP RETAINER REMOVAL
To remove the drain pump retainer, first remove the top plate
and drain pump assembly.
Remove the Top Plate
1 Use a T-20 Torx bit to remove the screws from the top and
back of the unit.
77
service.subzero.com