Wolf CSO24TE/S General Information Manual page 54

Cavity Component Removal and Installation
REMOVE THE REAR BAFFLE (continued)
2 Remove the rear baffle from the unit.
Remove the Hot Air Fan Blade
TIP: The hot air fan blade nut is reverse threaded.
1 Use a 10 mm socket to remove the nut from the hot air fan
blade.
2 Remove the washer and the hot air fan blade from the unit.
3 The washer and C-clip behind the hot air fan blade does not
need to be removed unless the convection fan motor is
being removed.
HOT AIR FAN BLADE INSTALLATION
Install the Hot Air Fan Blade
1 Install the C-clip and washer if they were removed for
replacement of the convection fan motor.
2 Install the hot air fan blade.
3 Install the washer.
TIP: The hot air fan blade nut is reverse-threaded.
827703 REV B.1
CSO (SWS #13543126)
4 Use a 10 mm socket to install the nut onto the hot air fan
blade.
Install the Rear Baffle
1 Place the rear baffle against the back wall of the oven
cavity.
2 Use a T-20 Torx bit to install the screws into the rear baffle.
Install the Rack Guide
1 Insert the rack guide rails into the rear baffle.
2 Place the indent in the rack guide over the rack guide stud.
3 Install the rack guide nut.
Install the Rack
1 Insert the rack between the rails of the rack guide.
2 Push the rack into the oven.
ELEMENT REMOVAL
To remove the element, first remove the racks, rack guides, and
rear baffle.
Remove the Rack
Pull the rack forward out of the unit.
Remove the Rack Guide
1 Remove the rack guide nut.
2 Pull the front of the rack guide toward the center of the
oven.
54
service.subzero.com