Table of Contents
Advertisement
Top Component Removal and Installation
Remove the Handle Actuator (continued)
Remove the Handle Actuator
1
Use a T-10 Torx bit to remove the handle actuator side
mounting screws.
2
Open the oven door.
3
Use a T-20 Torx bit to remove the handle actuator bottom
mounting screws.
4
Disconnect the wire harnesses from the handle actuator.
5
Remove the handle actuator from the control panel.
HANDLE ACTUATOR INSTALLATION
After installing the handle actuator, install:
1
Top plate
2
Unit
3
Water tank
Install the Handle Actuator
1
Connect the wire harnesses to the handle actuator.
2
Use a T-20 Torx bit to install the handle actuator bottom
mounting screws.
3
Use a T-10 Torx bit to install the handle actuator side
mounting screws.
4
Close the oven door.
DOOR SWITCH REMOVAL
To remove the door switch, first remove:
Water tank
1
Unit
2
Top plate
3
827703 REV B.1
CSO (SWS #13543126)
Remove the Door Switch
1
Disconnect the door switch wire connector from the control
board.
2
Open the door switch bracket tab and remove the door
switch from the door switch bracket.
DOOR SWITCH INSTALLATION
After installing the door switch, install:
1
Top plate
2
Unit
Water tank
3
Install the Door Switch
1
Place the door switch in the door switch bracket.
2
Connect the door switch wire connector to the control
board.
VALVE ASSEMBLY REMOVAL
The valve assembly includes:
•
Water valve
•
Water tank microswitch
•
Water tank drive motor
•
Water tank rail
To remove the valve assembly, first remove:
1
Water tank
Unit
2
Top plate
3
Remove the Valve Assembly
1
Remove the wire connectors from the water tank
microswitch.
57
service.subzero.com
Advertisement
Table of Contents
