Wolf CSO24TE/S General Information Manual page 53

Cavity Component Removal and Installation
Remove the Rack (continued)
Remove the Rack
Pull the rack forward out of the unit.
Remove the Rack Guide
1 Remove the rack guide nut.
2 Pull the front of the rack guide toward the center of the
oven.
3 Pull the rack guide forward out of the unit.
Remove the Rear Baffle
1 Use a T-20 Torx bit to remove the screws from the rear
baffle.
2 Remove the rear baffle from the unit.
REAR BAFFLE INSTALLATION
Install the Rear Baffle
1 Place the rear baffle against the back wall of the oven
cavity.
827703 REV B.1
CSO (SWS #13543126)
2 Use a T-20 Torx bit to install the screws into the rear baffle.
Install the Rack Guide
1 Insert the rack guide rails into the rear baffle.
2 Place the indent in the rack guide over the rack guide stud.
3 Install the rack guide nut.
Install the Rack
1 Insert the rack between the rails of the rack guide.
2 Push the rack into the oven.
HOT AIR FAN BLADE REMOVAL
To remove the hot air fan blade, first remove the racks, rack
guides, and rear baffle.
Remove the Rack
Pull the rack forward out of the unit.
Remove the Rack Guide
1 Remove the rack guide nut.
2 Pull the front of the rack guide toward the center of the
oven.
3 Pull the rack guide forward out of the unit.
Remove the Rear Baffle
1 Use a T-20 Torx bit to remove the screws from the rear
baffle.
53
service.subzero.com