Table of Contents
Advertisement
Top Component Removal and Installation
INSTALL THE CONTROL BOARD (continued)
3
Insert the ribbon cable into the ribbon cable connector and
lock the ribbon cable connector.
4
Connect the wire connectors to the control board.
DISPLAY REMOVAL
To remove the display, first remove the top plate and the control
board.
Remove the Top Plate
1
Use a T-20 Torx bit to remove the screws from the top and
back of the unit.
2
Remove the top plate from the unit.
827703 REV B.1
CSO (SWS #13543126)
Remove the Control Board
1
Open the lock(s) on the ribbon cable connectors, and
remove the ribbon cable(s) from the control board.
2
Disconnect the wire connectors from the control board.
3
Open the tabs on the control board bracket along the top of
the control board.
4
Remove the control board from the unit.
Remove the Display
1
Lift the tabs on the control board bracket at the top of the
display.
2
Remove the display from the unit.
60
service.subzero.com
Advertisement
Table of Contents
