Table of Contents
Advertisement
Top Component Removal and Installation
REMOVE THE TEMPERATURE SENSOR 300C (continued)
3
Remove the temperature sensor 300C from the top exhaust
duct.
Remove the Stepper Motor
1
Disconnect the electrical connector from the stepper motor.
2
Use a flat-blade screwdriver to pry the tabs up on the
stepper motor retainer, while pulling the stepper motor
toward the front of the unit.
3
Remove the stepper motor from the unit.
Remove the Top Exhaust Duct
1
Use a T-20 Torx bit to extract the screws from the top
exhaust duct.
2
Push the top exhaust duct toward the rear of the unit to
disengage the top exhaust duct tabs.
827703 REV B.1
CSO (SWS #13543126)
3
Remove the top exhaust duct from the unit.
TOP EXHAUST DUCT INSTALLATION
Install the Top Exhaust Duct
1
Place the top exhaust duct tabs into the notches in the top
of the unit.
2
Pull the top exhaust duct toward the front of the unit to lock
the top exhaust duct tabs in place.
3
Use a T-20 Torx bit to install the screws into the top exhaust
duct.
Install the Stepper Motor
1
Slide the stepper motor backward over the stepper motor
retainer until the stepper motor tabs lock into place.
2
Connect the electrical connector to the stepper motor.
Install the Temperature Sensor 300C
1
Insert the temperature sensor 300C into the top exhaust
duct.
2
Use a T-15 Torx bit to install the screw into the temperature
sensor 300C.
3
Connect the temperature sensor 300C electrical connector
to the unit relay board.
Install the Room Air Fan
1
Align the arrow on the room air fan with the open arrow on
the top exhaust duct.
2
Rotate the room air fan counterclockwise until the arrow on
top of the room air fan is aligned to closed on the top
exhaust duct.
68
service.subzero.com
Advertisement
Table of Contents
