Table of Contents
Advertisement
3- Configure Motion Detection Areas
Motion Detection allows for specific areas of the image to be used for triggering the recording of video, an alarm, or sending
a notification. When an area is defined, motion in that area will trigger the predefined action; this is useful to avoid unwanted
events from being triggered due to motion in areas of no concern.
Note: Motion for the entire viewable area is set by default; we recommend that smaller areas be defined unless this is
desired result.
See section
Adding a Motion Area
A.
Select Event Setting under Event on the left side Menu.
B.
Select the Area for Motion Detection.
B.1- Select Area 1 next to the blue box.
B.2- Place the mouse at the upper left hand corner of the area to mask, hold down the left mouse button and drag the
box over the area to mask and release the mouse button.
B.3- Select the Sensitivity level in the drop down box under the Area. (Range 1 Low to 10 High).
B.4- Select the checkbox next to the area and select the type of Events to perform when motion is detected on that area.
B.5- Select a Name to use for the Subject line of email notifications.
B.6- Set the Interval between motion events (the minimum time to wait before triggering subsequent motion events).
B.7- Repeat Steps A-G for Area 2 & 3 if more areas are needed.
C. Set the Delivery Media Format.
D. Select the File Format from the dropdown list.
E.
Select the time to Start and Stop the recording.
F.
Select Action to Perform when Connection is Lost.
Note: If Save to SD Card is selected, the Cameras must have a microSD Card installed.
G. Select Apply at the bottom of the screen to save the settings.
Removing a Motion Area
A.
Select the button for the area to remove. The colored grid for the selected area will be removed.
B.
Select Save to save the change.
4- Setup a Schedule
A.
Select Schedule under Event on the left side Menu.
B.
Select the Enabled checkbox.
C. Click on the box(es) to enable one-hour blocks of time for the desired Day of week and Time of day.
www.snapav.com Support: 866.838.5052
12.11.1-Motion Detection
for details on the features used in this step.
Draw Motion Area
WPS-750-BUL-IP Installation Manual
Pg. 21
Hide quick links:
Advertisement
Table of Contents
