Motion Detection - Wirepath Surveillance WPS-765-DOM-AH Installation Manual

6.4.2.13. MOTION DETECTION

With detection turned on, when the camera detects motion, a colored block will
appear on the screen to call attention to the view. Motion configuration allows
for up to 96 zones.
NOTE — It is suggested for most applications to use the motion detection settings
on the DVR rather than the camera. The camera will not initiate recording in the
DVR using this feature.
• DETECT SENSE — Level of sensitivity to changes in contrast within the selected
area.
• INTERVAL — Time delay from the first motion event to the subsequent event.
Motion alerts will not occur within this time delay.
• BLOCK DISP — Generates black or white inverted squares over the area that
motion is detected.
• MASK AREA— Select the portion of the grid you would like for motion to be
masked in. Each number is a grid of 4 blocks for which you can select, for a
total of 96 zones.
• MONITOR AREA—
• AREA SEL — Select one of the four areas to modify settings.
• AREA MODE — Toggle monitoring on or off for the area selected.
• Customize the size and the position of each detection zone by adjusting
TOP, BOTTOM, LEFT, and RIGHT values.
© 2014 Wirepath Surveillance
MOTION DETECTION
DETECT SENSE
INTERVAL
BLOCK DISP
MASK AREA
MONITOR AREA
RETURN
MONITOR AREA
AREA SEL
AREA MODE
TOP
BOTTOM
LEFT
RIGHT
RETURN
WPS-765-DOM-AH Installation Manual
50
50
OFF 08
064
128
1/4
OFF
10
10
10
10
23