Table of Contents
Advertisement
WPS-300-CUB-IP Installation Manual
9.5.2. Configuring Motion Detection Areas
Motion detection allows for specific areas of the image to be used for triggering the recording of video, an alarm, or sending a
notification. When an area is defined, motion in that area will trigger the predefined action; this is useful to avoid unwanted events
from being triggered due to motion in areas of no concern.
9.5.2.1.
Motion Detection Settings Overview
Area Setting
Area Setting Select the button to set the area for detection.
Adjustable from 1 (Requires higher amount of motion to trigger) to 10 (Requires low amount of motion
Sensitivity
to trigger).
•
•
•
Area 1, 2, 3
•
•
•
Subject
Text to use as subject of email notifications when they are sent.
Selects the minimum time between motion events that the camera will respond to. Higher values are
Interval
useful to reduce notifications for camera scenes with more expected motion.
Only in
Schedule
When selected, motion events will only be triggered based on a configured schedule.
Times
Click "Apply" at the bottom-right of the page to save modified settings.
56
(appears at bottom corner of page,
Area # - When selected the area is enabled allowing for the events defined below to occur.
E-Mail - check the box to send media via email. Requires configuration of Email Settings as
defined in section
9.3.8.2. Mail
FTP - check the box to save media to an FTP site or server. Requires configuration of FTP as
defined in section
9.3.8.3. FTP
SD Card - check the box to save media to a microSD card (if installed). See section
Menu
for more information about microSD card setup and use.
DO Out – Check to activate the DO contact output to trigger a connected device contact input.
Requires connection and configuration of DO output as defined in section
Network Share – check the box to save media to a Network Share location. Requires the
configuration of Network Share as defined in section
moved up for reference)
Settings.
Settings.
9.3.8.4. Network Share Settings
9.7. SD Card
7.3. Relay Connections.
Advertisement
Table of Contents
