Ect Sensor - Honda LEAD 110 2009 Service Manual

FUEL SYSTEM (Programmed Fuel Injection)
CIRCUIT INSPECTION
Support the scooter with its centerstand on a level
surface.
Remove the body cover (page 3-9).
Disconnect the bank angle sensor 6P (Black) con-
nector.
Turn the ignition switch "ON".
Measure the voltage at the bank angle sensor 6P
connector terminals of the wire harness side.
CONNECTION: Black (+) – Green (–)
STANDARD: Battery voltage
If there is no voltage, check the following:
– Open circuit in Black wire.
– Open circuit in Green wire.
If there is battery voltage, check the following:
Measure the voltage at the bank angle sensor 6P
(Black) connector terminals of the wire harness side.
CONNECTION: Red/Orange (+) – Green (–)
STANDARD: Battery voltage
If there is no voltage, check the open circuit in Red/
Orange wire.

ECT SENSOR

REMOVAL/INSTALLATION
Drain the coolant (page 7-8).
Remove the side body cover (page 3-4).
Disconnect the ECT sensor 3P connector from the
Remove the ECT
sensor.
sensor while the
engine is cold.
Remove the ECT sensor and sealing washer.
6-52
BANK ANGLE SENSOR
6P (Black) CONNECTOR
BANK ANGLE SENSOR
6P (Black) CONNECTOR
ECT SENSOR/SEALING WASHER
3P CONNECTOR
Bl
G
R/O
G