LIGHTS/METERS/SWITCHES
Install a new seal ring onto the fuel tank.
Install the fuel level sensor into the fuel tank, being
careful not to deform or damage the front arm.
Align the groove on the fuel level sensor with the T
r
,,,-, .,-.,,-,
cmenn
tab on the fuel tank.
-
F U E L L E V E L S E N S 0 R
Install the retainer aligning the its cut-outs with the
tabs on the fuel tank and turn the retainer clockwise
to lock it until the arrows are aligned.
Install the wire to the clamp.
Install the step floor (page 2-9).
COOLANT TEMPERATURE INDICATOR/
ECT SENSOR
NOTE:
• When the coolant temperature exceeds 120 °C
(248 °F), the coolant temperature indicator will
blink. The ECM will then control the ignition and
reduce engine speed to 9 mph (15 km/h). At this
time, check the cooling system and engine for
leaks or damage. If everything is OK, then check
the following.
• If the indicator lights up when the ignition switch
ON, check the short-circuit of the Light green/red
wire between the speedometer and ECM termi-
nals.
COOLANT TEMPERATURE INDICATOR f •///
18-14