Honda LEAD 110 2009 Service Manual page 329

FRONT WHEEL/SUSPENSION/STEERING
Apply engine oil to the handlebar post nut seating
surface and the bolt threads as shown.
Install the bolt, collars and nut as shown.
Tighten the nut to the specified torque.
TORQUE: 33 N·m (3.4 kgf·m, 24 lbf·ft)
Secure the cables with the handlebar clamp.
Route the cables
properly (page 1-
17).
HANDLEBAR GRIP
Apply Honda Bond A or equivalent to the inside of
the grip and to the clean surfaces of the left handle-
bar.
Wait 3 – 5 minutes and install the grip.
Allow the adhesive
Rotate the grip for even application of the adhesive.
to dry for 1 hour
before using.
COMBINED BRAKE EQUALIZER
Align the boss of the rear brake lever bracket with
the hole of the handlebar and install the rear brake
lever bracket.
Hook the bracket holder to the tab of the rear brake
lever bracket while holding the brake lever bracket.
Install and tighten the brake lever bracket holder
bolt.
THROTTLE HOUSING
Install the throttle pipe to the right handlebar.
Apply 0.1 – 0.2 g of grease to the throttle cable slid-
ing area and end or seat area.
Connect the throttle cable to the throttle pipe.
Install the lower throttle housing by aligning the
hole on the handlebar with the locating pin of the
lower throttle housing.
15-22
NUT
CLAMP
BOLT
HANDLEBAR GRIP
BRACKET
HOLDER
TAB
BOSS
THROTTLE PIPE
Align
2 – 5 threads
from the end
COLLARS
BOLT
HOLE
THROTTLE
CABLE
LOWER HOUSING