Honda LEAD 110 2009 Service Manual page 257

DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
Install the left crankcase cover onto the left crank-
case by aligning the dowel pins with the holes.
Install the brake cable holder, left crankcase cover
bolts and tighten the bolts in a crisscross pattern in
two or three steps.
Connect the air duct to the left crankcase cover by
aligning the air duct cut-off with the left crankcase
cover tab.
Tighten the band screw.
• Tighten the air duct band screw until the clear-
ance between the screw and band end is 4.0 ± 1.0
mm (0.16 ± 0.04 in)
DRIVE BELT
REMOVAL/INSTALLATION
• The drive belt can be serviced with the engine
installed in the frame.
Remove the following:
– Drive pulley face (page 11-8)
– Clutch/driven pulley (page 11-13)
Remove the drive belt and replace it if necessary.
Install the following:
– Clutch/driven pulley (page 11-21)
– Drive pulley face (page 11-11)
– Left crankcase cover (page 11-5)
11-6
LEFT CRANKCASE COVER
BRAKE CABLE HOLDER
AIR DUCT
BAND SCREW
4.0 ± 1.0 mm
(0.16 ± 0.04 in)
DRIVE BELT
BOLTS
Align