Honda LEAD 110 2009 Service Manual page 211

ENGINE REMOVAL/INSTALLATION
Remove the plug from the radiator joint and con-
nect the siphon hose to the radiator.
Remove the clamp from the siphon hose.
Secure the following with the wire band:
Route the wire har-
ness properly (page
– Alternator/CKP sensor wire
1-17).
– Engine sub harness
Connect the spark plug cap and set the plug wire
band to the right side cover.
Connect all connectors inside the boot.
Route the wire har-
ness properly (page
Secure the wires with the wire band and clamp.
1-17).
Set the ground cable to the frame and tighten the
bolt.
Install the following:
– Under cover (page 3-7)
– Rear fender (page 3-12)
– Body cover (page 3-9)
Adjust the following:
– Throttle grip freeplay (page 4-5)
– Rear brake lever freeplay (page 4-17)
8-10
CLAMP
PLUG
WIRE BANDS
SPARK PLUG CAP
GROUND CABLE
BOLT
SIPHON HOSE
CONNECTORS
WIRE CLAMP
WIRE BAND